- Does it matter which wire goes where on a single pole switch?
- Where do the wires go in a light switch?
- What happens if you mix up hot and neutral wires?
- What happens if you wire live and neutral wrong?
- What happens if you wire a light switch wrong?
- Can you wire a light switch without ground?
- Which wire goes on the gold screw?
- Does it matter which wire goes where on a light fixture?
Does it matter which wire goes where on a single pole switch?
There should be one wire only under each terminal.
One of these will likely be black.
The other may be black, red, or white.
One of these is the power feed, and one is the switch leg, but the switch terminals are interchangeable, so there is no need to identify which is which..
Where do the wires go in a light switch?
The white (neutral) wire connects to the silver screw, or you place it in the back wire hole on the same side of the device as the silver screw. The black (hot) wire goes to the brass screw or into the hole in the back of the device on the same side as the brass screw.
What happens if you mix up hot and neutral wires?
This happens when the hot and neutral wires get flipped around at an outlet, or upstream from an outlet. Reversed polarity creates a potential shock hazard, but it’s usually an easy repair. … This wire is commonly referred to as the neutral wire, and it should always be white.
What happens if you wire live and neutral wrong?
If the switch is put in the neutral line (like in your house) the switch and fuse comes in neutral line. In the switch OFF position the entire appliance will have 220V, touching any part will give you deadly shock. As per the rules, if live and neutral are reversed, Electricity board will not give power to your house.
What happens if you wire a light switch wrong?
You could put the switch on the neutral wire and everything would work, but it would leave voltage potential to ground in the light when it is switched off. That makes it a bit hazardous for changing light bulbs. If you became an electrical path to ground through a wet floor or something you could get a shock.
Can you wire a light switch without ground?
Going without a ground wire If the light switch has a screw for a bare ground wire but your electrical box doesn’t have one, you’re OK just leaving that screw empty and connecting your other wires to the hot screws. … If the box isn’t grounded, the switch will still work.
Which wire goes on the gold screw?
Black (Hot) goes on the smaller prong side or white to silver screws, black to gold screws. Ground (bare wire) to green.
Does it matter which wire goes where on a light fixture?
You may see a stripe on one of the wires. If so, that wire is neutral. If the plastic is clear, the wires in the neutral side are silver while those in the hot side are copper. After determining the polarity, connect the hot wire to the black circuit wire and the neutral wire to the white circuit wire.